TM 10-5410-221-24
for connection of appliances and accessories within the
wire (5) from the receptacle (4) and remove receptacle
expandable shelter. The receptacles consist of a duplex
from housing.
receptacle installed in a housing. See figure 1-3 for
c. Test.
location and identification of receptacles. See figure 1-7
Check continuity of convenience
for electrical schematic.
receptacles using a continuity light, multimeter or other
continuity checking device. Refer to figure 1-7 for wire
b. Removal.
routing and terminal identification. Continuity must exist
through receptacle outlets and terminals.
Replace
(1) Remove screw (1, fig. 6-21) securing the
receptacle if continuity does not exist or if any evidence
receptacle cover plate (2) to the receptacle.
of shorting is present.
(2) Remove
screws
(3)
securing
the
d. Installation. Install convenience receptacles in
receptacles (4) to the receptacle housing.
reverse order of removal using figure 6-21 as a guide.
(3)
Disconnect electrical leads and jumper
6-31
