TM 10-5410-221-14/1
1. Terminal (7)
3. Washer (8)
5 Cover plate
7. Connector
2. Nut (4)
4. Screw (4)
6. Sleeving, insulation
8. Wire
9. Wire
Figure 6-22. Humidifier Wiring Harness Assembly (TS 013807)
follows:
NOTE
(1) Install wiring harness to electrical raceway.
Cuts
or
abrasions
of
harness
(2) Install screws to secure cover (5, fig. 6-22)to
assemblies may be due to sharp edges
receptacle box.
of electrical raceways, interference with
(3) Install electrical leads to terminal (38, fig. 3-7,
other components or improper handling.
sheet 2 of 5), terminal (28) and terminal (45) in he power
The cause shall be determined and
distribution box.
eliminated before installation of the
harness assemblies.
g. Installation. Install humidifier wiring harness as
Section III. LIGHT ASSEMBLIES AND CONVENIENCE RECEPTACLES
6-17. General
6-18. Air Lock Light Assembly
a. General. The air lock light assembly provides
This section contains the light assemblies used for
illumination in the shelter and air lock chamber and the
illumination in the air lock chamber. The light assembly
convenience receptacles used for connection of
consists of a junction box, lamp socket, incandescent
electrical appliances along the shelter walls and ceiling.
lamp and a wiring harness.
They consist of an air lock chamber light assembly, six
b. Removal. Remove air lock light assembly, by
fluorescent light assemblies and twelve convenience
receptacles.
disconnecting cable assembly from light assembly,
6-30
