TM 10-5410-221-14/1
b. Disassembly. Refer to figures 6-5 and 6-6 and
(13) Remove blind nuts (69), rivets (70) and
extrusion (71).
disassemble as follows:
(14) Remove guard (72), rivets (73), and
(1) Remove rivets (1, fig. 6-5, sheet 1 of 3)
extrusion (74).
securing doublers (2 and 3), and remove inserts (4).
(15) Remove rivets (75) and extrusion (76);
(2) Remove rivets (5).
remove base (77).
(3) Remove screws (6), washers (7 and 8), and
(16) Remove blind nuts (78, 79 and 80), rivets
rivets (9); remove plate assembly (10).
(81) and angle (82).
(4) Disassemble plate assembly by removing duct
c. Repair. If possible, straighten any bent connector
liner (11), rivets (12), angle (13), rivets (14),
pins. Inspect wires for abrasions and cuts of insulation.
stiffeners (15 and 16) and plate (17).
Minor cuts and abrasions are acceptable and may be
(5) Disassemble plate assembly (18) as follows:
(a) Remove duct liners (19), rivets (20), and
repaired by wrapping with vinyl tape. Replace harness
assembly if individual wires are cut or otherwise
angle (21).
(b) Remove rivets (22), stiffeners (23), and
damaged.
plate (24).
NOTE
(6) Disassemble plate assembly (25) as follows:
Cuts or abrasions of harness
(a) Remove duct liner (26), rivets (27), and
assemblies may be due to sharp edges
angle (28).
of electrical raceways, interference with
(b) Remove rivets (29), stiffeners (30, 31, 32
other
components
or
improper
and 33), and plate (34).
handling.
The cause shall be
(7) Disassemble fixed floor assembly (35, fig. 6-
determined and eliminated before
5, sheet 2 of 3) by removing screws (36), panel
installation of the harness assemblies.
assembly (37) and blocks (38, 39, and 40).
(8) Remove screws (41, fig. 6-5, sheet 3 of 3),
d. Assembly. Using figure 6-5, assemble items as
washers (42), rivets (43), blind nuts (44 and 45) and
follows:
angles (47, 48, 49, 50, 51 and 52).
(1) Install extrusion (89, fig. 6-5, sheet 3 of 3),
(9) Remove blind nuts (53 and 54), rivets (55),
rivets (88) and nuts (87).
and extrusion (56).
(2) Install base (86), extrusion (85), rivets (84),
(10) Remove rivets (57), washers (58 and 59),
and blind nuts (83).
and transporter assemblies (60).
(3) Install angle (82), rivets (81), and blind nuts
(11) Remove pin (61), slide assembly (62),
(78, 79 and 80).
housing assembly (63) and spacers (64).
(4) Install base (77), extrusion (76), and rivets
(12) Remove blind nuts (65), rivets (66), angles
(75).
(67), and closeouts (68).
(5) Install extrusion (74), rivets (73) and guard
(72).
Figure 6-6. 400 Hertz Power In Harness Assembly (TS 013787)
6-9
