TM 10-5410-221-14/1
Figure 4-12. Fluorescent Light Assembly - Disassembly (Sheet 3 of 3) (TS 013754)
(5) Remove screws (3, fig. 4-12, sheet 1 of 3) and
(4) Remove lamp clips (20) by removing rivet (19).
pull out light assembly (4) for repair or replacement on
(5) Remove grommet (21) from light box (22).
bench or table top.
b. Disassembly.
Disassemble fluorescent light
lens (24) by peeling from cemented area of lens frame
(25).
assembly (4, fig. 4-12, sheet I of 3) to repair or replace
damaged parts by observing sequence of index numbers
the light assembly and observe the following
(1) Disconnect ballast leads (13, fig. 4-12, sheet 2
lens (24) using the two part adhesive from the repair kit.
of 3) from terminal board (15).
(2) Remove nuts (13), washers (14) and remove
terminal board (15).
(3) Remove nuts (16), washers (17) and remove
Change 1 4-64