TM 9-2330-390-14&P
2-20. OPERATING ENGINE (Con't).
NOTE
If engine Is being started for first time and Is fully cooled, use of decompression lever
may be required.
(4)
Turn starter switch (2) to ST position. When engine starts, release starter switch.
(5)
Set speed control lever (5) to LOW position. Idle engine for three minutes to warm engine.
(6)
Set speed control lever (5) to HIGH START position when operating hydraulic control valve.
b. Shutting Down Engine.
(1)
Before shutdown, set speed control lever (5) to LOW position and idle engine for three minutes.
(2)
Push stop lever (4) to the right to STOP position.
(3)
As soon as engine stops, turn starter switch (2) to OFF position. Remove key (3).
2-130
