TM 9-2330-379-14&P
AFTER USE - CONTINUED
Uncoupling Dolly Set From Shelter
WARNING
Uncoupling the dolly set from the shelter should not be attempted unless the shelter is
resting firmly on the ground.
1.
When the shelter is resting firmly on the ground, disconnect the intervehicular brake air lines
from the front (1) and rear (2) dollies.
2.
Stow the brake air hoses on the rear dolly (2).
3.
Disconnect the interdolly electrical cable (3) between front dolly junction box (4) and rear dolly
connector (5).
4.
Stow the interdolly electrical cable on the rear dolly (2).
5.
Remove the upper ISO pins (6) from both the front and rear shelter ISO.
6.
Stow the pins and sockets in the tool box (7).
7.
Remove the dolly caster assemblies (8) from stowage on the front dolly by pulling out retaining
pins (9).
8.
Install the dolly casters on the rear dolly (2).
9.
Adjust the dolly caster (8) to permit movement of lower ISO pins.
10.
Remove the lower ISO pins (10) from the shelter.
11.
Release rear dolly parking brake by moving parking brake lever (11) to OFF position.
12.
Depress auxiliary brake control knob (12) to release service brakes.
13.
Pull rear dolly away from container/shelter.
14.
Set rear dolly parking brake by moving parking brake lever (11) to ON position, or pull out
auxiliary brake control knob (12) to apply service brakes.
15.
Adjust dolly caster assemblies (8) to allow rear dolly to rest on the ground.
16.
Remove dolly caster assemblies (8) from rear dolly.
17.
Install dolly caster assemblies on front dolly (1).
18.
Remove the lower ISO pins from the front of the container/shelter.
2-43
