TM 9-2330-37914&P
DATA PLATES
This task covers:
a.
Removal (page 4-180)
b.
Installation (page 4-180)
INITIAL SETUP:
Tools
Equipment Conditions
General mechanics tool set
No special requirements.
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
The following procedures for removal and
installation are typical for all the data
plates on the front and rear dolly. Refer to
page 1-9 and 1-10 for location of other data
plates.
1
Tow bar (1)
Shipping data
Remove four drive screws (3) attaching
plate (2) and
shipping data plate (2) to tow bar (1).
four drive
screws (3)
2
Tool box
Lubrication
Remove four screws (6) and four nuts (7)
(4)
chart data plate
attaching lubrication chart data plate (5)
(5), four screws
to top of tool box.
(6) and four
nuts (7)
INSTALLATION
3
Tool box
Lubrication chart
Attach lubrication chart data plate (5)
(4)
data plate (5),
to top of tool box (4) with four screws
four screws (6),
(6) and four nuts (7).
and four nuts
(7)
4
Tow bar
Shipping data
Attach shipping data plate (2) to tow
(1)
plate (2), and
bar (1) with four screws (3).
four screws (3)
4-180
