TM
11-5410-213-14P-1
specifies, by the listing of a "work time" figure in
alphabetic code which leads to the remark in section
the appropriate subcolumn(s), the lowest level Of
IV, Remarks, which is pertinent to the item op-
maintenance authorized to perform the function
posite the particular code.
listed in column 3. This figure represents the active
C-4. Tool and Test Equipment Requirements (Sect.
time required to perform that maintenance function
III).
at the indicated category of maintenance. If the
number or complexity of the tasks within the listed
a. Tool or Test Equipment Reference Code. The
maintenance function vary at different maintenance
numbers in this column coincide with the numbers
categories, appropriate "work time" figures will be
used in the tools and equipment column of the MAC.
shown for each category. The number of task-hours
The numbers indicate the applicable tool or test
specified by the "work time" figure represents the
equipment for the maintenance functions.
average time required to restore an item (assembly.
b. Maintenance Category. The codes in this
subassembly, component, module, end item or
column indicate the maintenance category allocated
the tool or test equipment.
system) to a serviceable condition under typical
field operating conditions. This time includes
c. Nomenclature. This column lists the noun
name and nomenclature of the tools and test
preparation time, troubleshooting time, and quality
equipment required to perform the maintenance
assurance/quality control time in addition to the
functions.
time required to perform the specific tasks iden-
tified for the maintenance functions authorized in
d. National/NATO Stock Number. This column
the maintenance allocation chart. Subcolumns of
lists the National/NATO stock number of the
column 4 areas follows:
specific tool or test equipment.
e. Tool Number. This column lists the
COperator/Crew
OOrganizational
manufacturer's part number of the tool followed by
FDirect Support
the Federal Supply Code for manufacturers (5-digit)
.
HGeneral Support
in parentheses.
DDepot
C-5. Remarks (Sect. IV).
e. Column 5, Tools and Equipment. Column 5
specifies by code, those common tool sets (not in-
a. Reference Code. This code refers to the ap-
dividual tools) and special tools, test, and support
propriate item in section II, column 6.
b. Remarks. This column provides the required
equipment required to perform the designated
function.
explanatory information necessary to clarify items
appearing in section II.
f. Column 6, Remarks. Column 6 contains an
(Next printed page is C-3)
C-2
