TM 10-9925-100-12&P
0005 00
PREPARE POWER DISTRIBUTION SYSTEM FOR USE
WARNING
Do not attempt to connect the power source to the C.C. Only MOS 51R, 52C,
52D, or 52G qualified personnel can perform this procedure. Serious injury
and death can result from electrical shock.
NOTE
One of the supplied fire extinguishers should be maintained in the vicinity of the TQG (if
used) during refueling and operation.
Refer to TM 9-6115-671-14 Generator set, Skid Mounted, Tactical Quiet,(if used), for set up, operation
and maintenance of the generator and grounding rod.
Refer to TM 10-8340-224-13 Tent, Extendable, Modular, Personnel (TEMPER) for procedures regarding
installation, operation and maintenance of the power distribution system.
1. Connect pigtails to the power source (Commercial or TQG).
NOTE
Lay out 60 AMP, 100-ft power cables where they are not subjected to vehicular traffic or
are a safety hazard to Containerized Chapel users.
2. Connect the two 60 AMP-100 ft power cables to the pigtails, and to the TEMPER power control box
input connectors (1).
3. Connect TEMPER extension cords (2) to the TEMPER power control box output connectors (3) and
convenience outlets (4).
NOTE
Place power distribution boxes and convenience outlets at locations within the TEMPER
where power will be required. This may vary, depending on the desired configuration.
2
4
3
1
0005 00-9
