TM 10-8340-243-13&P
0005
Fabric Sections
NOTE
The MCPS roof cap and roof cap liner can only be removed after the frame has been
lowered.
NOTE
If bootwalls are employed, remove IAW TM 10-5410-230-13.
1. Close all windows (Figure 27, Item 1) and loosen all tent lines (Figure 27, Item 2). Do not remove
lines.
2. Release all quick disconnect (Figure 27, Item 3) and hook and pile fasteners (Figure 27, Item 4) at
inside and outside corners.
3. If fitted, remove the rain gutter liner and then the rain gutter (Figure 27, Item 5) from the inside of the
MCPS by unfastening all quick disconnect (Figure 27, Item 3) and hook and pile fasteners (Figure
27, Item 4).
Fold with identification label visible and place in
fabric transport bag.
4. Remove the telescopic poles (Figure 27, Item 6) at entrance way by pushing up on the locking
device (Figure 27, Item 7). Collapse poles and place them in the frame transport bag.
5. Remove steel pins (Figure 27, Item 8) from entrance way wall (Figure 27, Item 9) and place in tent
pin container.
6. Close and secure left (Figure 27, Item 10) and right (Figure 27, Item 11) blackout doors and outer
and hook and pile fasteners (Figure 27, Item 4). Fold each liner with identification label visible and
place in fabric transport bag.
8. Release quick disconnect fasteners (Figure 27, Item 15) connecting the floor (Figure 27, Item 16) to
the walls. Remove and fold floor with identification label visible and place in fabric transport bag.
9. Remove walls by releasing all quick disconnect (Figure 27, Item 3) and hook and pile fasteners
(Figure 27, Item 4).
Fold the wall assemblies with identification labels visible and place in
fabric
transport bag.
10. Release the remaining quick disconnect fasteners (Figure 27, Item 17) holding the roof cap (Figure
0005-28