TM 10-8340-240-12&P
0004 00-15
MODULAR GENERAL PURPOSE TENT SYSTEM (MGPTS)
0004 00
OPERATIONS UNDER USUAL CONDITIONS
INSTALL LIGHT ASSEMBLIES
Use these procedures to complete installation of the light hangers. (WP 0034 00, Item 3)
a. Inside light set case (1), locate light support strap assembly (2). (See Figure 0004 00-18).
Figure 0004 00-18 Light Assemblies
b. Inside tent, locate light hanger (5) at peak of End Section fabric. (See Figure 0004 00-19).
c. Place one end (4) of light support strap assembly (2) through loop (6) on end of lighting hanger
(5). The D-rings should now be facing the ground.
d. Light support strap assembly (2) is then folded over itself so that D-rings (7) and (8) face the
tent roof. (See Figure 0004 00-19).
e. Pull the end (4) of light support strap assembly (2) through both D-rings (7) and (8) on
assembly. Loop end (4) of assembly around the second D-ring (7) and through the first D-ring
(8) to secure.
f. Locate light hanger attached on inside of fabric near socket for Center Pole.
g. Secure other end of light support strap assembly (2) to light hanger and secure in similar
manner.
h. Repeat procedure (b) through (g) for light strap assembly between the Mid and End Section.
