TM 10-8340-226-13&P
CHAPTER 2
OPERATING INSTRUCTIONS
Subject
Section/Paragraph
Description and Use of Operator's Controls and Indicators............................................................
I
Operator's Controls and Indicators.......................................................................................
2-1
Operator's Preventive Maintenance Checks and Services ............................................................
II
Introduction .........................................................................................................................
2-2
Operation under Usual Conditions ................................................................................................
III
Assembly and Preparation for Use ......................................................................................
2-3
Unpacking and Inspection. ..................................................................................................
2-4
Assembly and Installation Instructions .................................................................................
2-5
Operation of Doors and Windows ........................................................................................
2-6
Decals and Instruction Plates ..............................................................................................
2-7
Preparation for Movement...................................................................................................
2-8
Operation under Unusual Conditions.............................................................................................
IV
General ...............................................................................................................................
2-9
SECTION I. DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS
2-1. OPERATOR'S CONTROLS AND INDICATORS. There are no controls or indicators applicable to this
equipment.
SECTION II. OPERATOR'S PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-2. INTRODUCTION. FSCT components must be inspected regularly to find and correct defects. Record all
defects found during the performance of PMCS and the steps taken to correct them on a DA Form 2404,
Equipment Inspection and Maintenance Worksheet. Instructions for reporting/correcting noted deficiencies are
contained in DA PAM 738-750
a. General. Table 2-1 (PMCS Table) has been provided so you can keep your equipment in good
operating condition and ready for its primary mission.
(1) Before you operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your before
(B) PMCS prior to the equipment leaving its containment area or performing its intended mission.
(2) While you operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your DURING
(D) PMCS when the equipment is being used in its intended mission.
(3) After you operate. Be sure to perform your after (A) PMCS after the equipment has been taken out
of its mission mode or returned to its containment area.
2-1
