COLUMN ENTRIES

TOOL AND TEST EQUIPMENT REQUIREMENTS (Sect. III) (CONT)

TM-10-8340-224-13 Tent Extendable Modular Personnel (Temper) Manual
Page Navigation
145

ARMY TM 10-8340-224-13 AIR FORCE TO 35E5-6-1 NAVY NAVFAC-P-337.A c. Column 3 - Maintenance Functions. Column 3 lists the functions to be performed on the item listed in column 2. When items are listed without maintenance functions, it is solely for the purpose of having the group number in the MAC and RPSTL coincide. d. Column 4 - Maintenance Cateqory. Column 4 specifies, by the listing of “work time” figures in the appropriate subcolumn(s), the lowest level of maintenance authorized to perform the function listed in column 3. This figure represents the active time required to perform that maintenance function at the indicated category maintenance. If the number or complexity of the tasks within the listed maintenance function vary at different maintenance categories, appropriate “work time” figures will be shown for each category. The number of task-hours specified by the “work time” figure represents the average time required to restore an item (assembly, subassembly, component, module, end item or system) to a serviceable condition under typical field operating conditions. This time includes preparation time, troubleshooting time, and quality assurance/quality control time in addition to the time required to perform the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. Subcolumns of column 4 are as follows: C Operator/Crew O Unit F Direct Support H General Support D Depot e. Column 5 - Tools and Equipment. Column 5 specifies by code, those common tool sets (not individual tools) and special- tools, test, and support equipment required to perform the designated function. f. Column 6 - Remarks. When applicable, this column contains a letter code, in alphabetical order, which is keyed to the remarks contained in Section IV. B-4 . TOOL AND TEST EQUIPMENT REQUIREMENTS (Sect. III) a. Tool or Test Equipment Reference Code. The numbers in this column coincide with the numbers used in the tools and equipment column of the MAC. The numbers indicate the applicable tool or test equipment for the maintenance functions. B-3

Privacy Statement
Press Release
Contact