EXPLANATION OF COLUMN IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III

EXPLANATION OF COLUMNS IN THE MAC, SECTION II - TM-10-5411-224-14_104

SECTION II. MAINTENANCE ALLOCATION CHART - TM-10-5411-224-14_106

TM-10-5411-224-14 Lightweight Multipurpose Shelters (LMS) Model No. S-78B/G Type I and Type III & 5411-01-357-3683 Manual
Page Navigation
96

TM 10-5411-224-14 d. Column 4, Maintenance Category (cont.). The work time figure represents the average time required to restore an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field operating conditions. This time includes preparation time (including any necessary disassembly/assembly time), troubleshooting/fault location time, and quality assurance time in addition to the time required to perform the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol designations for the various maintenance levels are as follows: C ......................................................................................................... Operator or crew maintenance 0 ........................................................................................................... Unit maintenance F ........................................................................................................... Direct support maintenance H .......................................................................................................... General support maintenance e. Column 5, Tools and Test Equipment Reference Code. Column 5 specifies, by code, those common tool sets (not individual tools), common TMDE, and special tools , special TMDE, and special support equipment required to perform the designated function. Codes are keyed to tools and test equipment in section II. f. Column 6, Remarks, When applicable, this column contains a letter code, in alphabetical order, which is keyed to the remarks contained in Section III. B-4. EXPLANATION OF COLUMN IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III. a. Column 1, Reference Code. The tool and test equipment reference code correlates with a code used in the MAC, section II, column 5. b. Column 2, Maintenance Level. The lowest level of maintenance authorized to use the tool or test equipment. c. Column 3, Nomenclature. Name or identification of the tool or test equipment. d. Column 4, National Stock Number. The National Stock Number of the tool or test equipment. e. Column 5, Tool Number. The manufacturer's part number, model number, or type number. B-3

Privacy Statement
Press Release
Contact