TM 10-5411-200-14
T.O. 35E4-177-1
4-19.
(cont)
7.
Position spring tension clip
(12) on outside tube (20) and
install screws (11).
8.
Assemble O-rings (29) on
handle (5).
9.
Position handle (5) in support
(6) and on jack screw (19) with
holes in handle yoke and jack
screw aligned.
Install pins
(3 and 4).
100
Install spring plunger (2) in
handle yoke and secure with nut
(1).
Adjust nut to control
handle movement.
11.
Position basic jack on base (17)
with spacers (16) and secure with
pin (15), washer (14), and new
cotter pin (13).
12.
Install grease fitting (7) and
lubricate jack with grease.
4-20.
HINGED ROOF PANEL SERVICE, REPLACEMENT, REPAIR, AND ALIGNMENT
This task covers:
a. Lubrication
e. Repair
b.
Removal
f.
Assembly
c. Disassembly
g. Installation
d.
Cleaning, Inspection
h.
Alignment
INITIAL SETUP
Special Tools
Equipment Condition
Hand blind riveter, Appendix B, Item 2
Hinged endwalls removed,
Standard Tools
paragraph 4-21
General mechanics tool kit
Hinged roof area ceiling
Personnel - 4
lights removed, paragraph
1 Electrician
3-5
Materials
Adhesive, Item 2, Appendix E
Adhesive, Item 3, Appendix E
Sealant, Item 18, Appendix E
Silicone Grease, Item 23, Appendix E
4-81
