COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS
Section I. INTRODUCTION
C-1. SCOPE. This appendix lists components of end item (COEI) and basic issue items (BII) for SICPS Boot Walls.
Use it to help inventory items required for safe and efficient operation.
C-2. GENERAL. The Components of End Item and Basic Issue Items Lists are divided into the following sections.
a. Section II. Components of End Item List. This listing is for informational purposes only, and is not authority to
requisition replacements. These items are part of the end item. They are removed and separately packaged for
transportation or shipment only when necessary. As part of the end item, these items must be with the end item
whenever it is issued or transferred between property accounts. Illustrations are furnished to assist you in identifying the
b. Section III. Basic Issue Items List. These are the minimum essential items required to place the bootwalls in
operation and to perform emergency repairs. Although shipped separately packaged, BII must be with the bootwalls
during operation and whenever it is transferred between property accounts. The illustrations will assist you with hard-to-
identify items. This manual is your authority to request/requisition replacement BII based on TOE/MTOE authorization of
the end item.
C-3. EXPLANATION OF COLUMNS. The following provides an explanation of columns found in the tabular listings:
a. Column (1) - Illustration/Item Number. Indicates the number of the illustration in which the item is shown and the
number of the item.
b. Column (2) - National Stock Number. Indicates the National stock number assigned to the item and is used for
c. Column (3) - Description. Indicates the federal item name and if required a minimum description to identify and
locate the item. The last line for each item indicates the Federal Supply Code for Manufacturer (FSCM) or Commercial
and Government Entity Code (CAGEC) in parentheses, followed by the part number. If the item you need is not the
same for different models of the equipment, a Usable On Code (UOC) will appear on the right side of the description
column on the same line as the part number. These codes are identified below:
UOC .................. MODEL
FJG ................... M577 BOOT WALL, TYPE I, GREEN
FJH ................... M577 BOOT WALL, TYPE I, TAN
FJJ ................... RWS BOOT WALL, TYPE II, GREEN
FJL ................... RWS BOOT WALL, TYPE II, TAN
FJL ................... S-250E BOOT WALL, TYPE IV, GREEN
FJM .................. S-250E BOOT WALL, TYPE IV, TAN
d. Column (4) - Unit of Measure (U/M). Indicates the measure used in performing the actual
operational/maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g. ea, in,
e. Column (5) - Quantity required (Qtv rqr). Indicates the quantity of the item authorized to be used with/on the