TM 10-5410-229-13&P
B-3.
COLUMN ENTRIES.
a.
Column 1- Group Number. Column 1 lists group numbers, the purpose of which is to identify components,
assemblies, subassemblies, and modules with the next higher assembly.
b.
Column 2 - Component/Assembly. Column 2 contains the noun names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
c.
Column 3 - Maintenance Functions. column 3 lists the functions to be performed on the item listed in column 2.
When items are listed without maintenance functions, it is solely for the purpose of having the group number in the MAC
and RPSTL coincide.
d.
Column 4 - Maintenance Category. Column 4 specifies, by the listing of "work time" figures in the appropriate
subcolumn(s), the lowest level of maintenance authorized to perform the function listed in column 3. This figure
represents the active time required to perform that maintenance function at the indicated category maintenance. If the
number or complexity of the tasks within the listed maintenance function vary at different maintenance categories,
appropriate "work time" figures will be shown for each category. The number of task-hours specified by the "work time"
figure represents the average time required to restore an item (assembly, subassembly, component, module, end item or
system) to a serviceable condition under typical field operating conditions. This time includes preparation time,
troubleshooting time, and quality assurance / quality control time in addition to the time required to perform the specific
tasks identified for the maintenance functions authorized in the maintenance allocation chart. Subcolumns of column 4 are
as follows:
C
Operator/Crew
O
Organizational
F
Direct Support
H
General Support
D
Depot
e.
Column 5 - Tools and Equipment. Column 5 specifies by code, those common tool sets (not individual tools) and
special-
B-3
