TM 10-5410-223-14/1
C1
APPENDIX C
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
(1) Figure Number. Indicates the figure
1. Scope
number of the illustration on which the item is
This appendix lists Integral Components of and
shown (if applicable).
Basic Issue Items (BII) for the Shelter, Multi-
(2) Item Number. The number used to iden-
purpose to help you inventory items required for
tify item called out in the illustration.
safe and efficient operation.
b. National Stock Number (NSN). Indicates
the primary number used by the manufacturer
which controls the design and characteristics of the
2. General
item by means of its engineering drawings, specifi-
The components of end item list are divided into
cations, standards and inspection requirements to
the following section:
identify an item or range of items.
a. Section II. Integral Components of the
d. Description. Indicates the federal item
End Item. These items, when assembled, comprise
name and, if required, a minimum description to
the Shelter, Multipurpose and must accompany it
identify the item.
whenever it is transferred or turned in. These illus-
e. Location. The physical location of each item
trations will help you identify these items.
listed is given in this column. The lists are designed
b. Section III. Basic Issue Items. These are
to inventory all items in one area of the major item
minimum essential items required to place the
before moving on to an adjacent area.
Shelter, Multipurpose in operation, to operate it and
f. Usable on Code. "USABLE ON" codes are in-
to perform emergency repairs. Although shipped
cluded to help you identify which component items
separately packed, they must accompany the Shel-
are used on the different models. Identification of
ter, Multipurpose during operation and whenever it
the codes used in this list are:
is transferred between accountable officers. The il-
USED ON
CODE
lustrations will assist you with hard-to-identify
(Not applicable)
items. This manual is your authority to requisition
g. Quantity Required (Qty Reqd). This col-
replacement BII based on Table(s) of Organization
umn lists the quantity of each item required for a
and Equipment (TOE) /Modification Table of Or-
complete major item.
ganization and Equipment (MTOE) authorization
h. Quanity. This column is left blank for use
of the end item.
during inventory. Under the received column, list
the quantity you actually receive on your major
item. The date columns are for use when you inven-
3. Explanation of Columns
tory the major item at a later date, such as for. ship-
a. Illustration. This column is divided as
ment to another site.
follows:
Change 1, C-1