TM 10-5410-223-14/1
Figure 4-22. Access door assemblies, removal and installation (sheet 3 of 3 ).
(1) Position the door panel, figure 4-22 (sheet 3
b. Inspection.
of 3), onto the shelter wall.
(1) Inspect all parts for wear and damage.
(2) Swing door outward, figure 4-22 (sheet 2 of
(2) Inspect door panels for wear and damage.
3), and install mounting screws.
c. Repair.
(3) Swing door inward, figure 4-22 (sheet 1 of
(1) Replace all worn and damaged parts.
3), and install mounting screws.
(2) Repair the damaged doors using the ap-
propriate repair procedure given at the beginning of
4-23. Removable End and Side Panel Assembly
this section.
a. Removal.
d. Installation.
(1) Remove screws and washers, figure 4-23,
NOTE
and remove the end panel.
Installation procedures listed below are appropriate
(2) Follow the same procedure, as above, when
for both door assemblies.
removing the side panel.
4-72
