TM 10-5410-221-14/1
APPENDIX C
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
(2) Item Number. The number used to identify
1. Scope
item called out in the illustration.
This Appendix lists integral components of, and
b. National Stock Number (NSN). Indicates the
basic issue items for, the Shelter, Expandable to help
national stock number assigned to the item and which
you inventory items required for safe and efficient
will be used for requisitioning.
operation.
c. Part Number (P/N). Indicates the primary number
used by the manufacturer, which controls the design and
2. General
characteristics of the item by means of its engineering
The components of end item list are divided into the
drawings, specifications, standards, and inspection
following sections:
requirements to identify an item or range of items.
a. Section II. Integral Components of the End
d. Description. Indicates the federal item name and,
Item. These items, when assembled, comprise the
if required, a minimum description to identify the item.
Shelter, Expandable and must accompany it whenever it
e. Location. The physical location of each item
is transferred or turned in. These illustrations will help
listed is given in this column. The lists are designed to
you identify these items.
inventory all items in one area of the major item before
b. Section IlI. Basic Issue Items. These are
moving on to an adjacent area.
minimum essential items required to place the Shelter,
f. Usable on Code. "USABLE ON" codes are
Expandable in operation, to operate it, and to perform
included to help you identify which component items are
emergency repairs. Although shipped separately packed
used on the different models. Identification of the codes
they must accompany the Shelter, Expandable during
used in this list are:
operation and whenever it is transferred between
CODE USED ON
accountable officers. The illustrations will assist you with
(Not applicable)
hard-to-identify items. This manual is your authority to
requisition re- placement BII, based on Table(s) of
g. Quantity Required (Qty Reqd). This column lists
Organization and Equipment (TOE/Modification Table of
the quantity of each item required for a complete major
Organization and Equipment (MTOE) authorization of the
item.
end item.
h. Quantity. This column is left blank for use during
inventory. Under the Rcvd column, list the quantity you
3. Explanation of Columns
actually receive on your major item. The Date columns
a. Illustration. This column is divided as follows:
are for use when you inventory the major item at a later
(1) Figure Number. Indicates the figure number
date, such as for shipment to another site.
of the illustration on which the item is shown (if
applicable).
Change 1 C-1
