M1070 HET ARMOR KIT
II113400
Rev. D
4. Install escape hatch panel assembly as follows (see Figure 3-87):
a. Carefully lift and position escape hatch panel assembly against rear panel and align four welded studs on
escape hatch panel assembly with four holes in rear panel.
b. Latch and clamp escape hatch panel assembly securely against rear panel using four Destaco clamps
mounted inside cab.
c. Adjust grip length of the Destaco clamps as required to provide adequate compression of escape hatch
panel assembly seal.
NOTE
The Escape Hatch stud ends should end up approximately flush with the inside
surface of the rear armor panel when the clamps are secured.
INSTALLATION 3-176
JUNE 2005
