M1070 HET ARMOR KIT
II113400
Rev. D
2. Pre-assemble left aft side panels as follows (see Figure 3-19):
a. Align left aft side panel (1) with left aft side panel (2) and install two lift brackets (3) and secure each
with one bolt (4), flat washer (5), and locknut (6). Verify hole-alignments using drill bushings as gauge
in holes marked "A". Torque bolts to 35 lb-ft.
b. Install the roof-side armor panel (7) onto left aft side panel assembly and secure it with
eight bolts (4), flat washers (5), and locknuts (6). Torque bolts to 35 lb-ft.
c. Install two 90-degree joiner brackets (8) onto left aft side panel assembly and secure each with
three flat washers (5) and locknuts (6). Do not tighten locknuts at this time.
d. Install eight bolts (9), sixteen flat washers (5), and eight locknuts (6) into left aft side panel assembly.
Torque bolts to 35 lb-ft.
INSTALLATION 3-36
JUNE 2005
