TB 9-2320-360-13&P-2
LEFT CAB SIDE (FRONT) ARMOR AND DOOR HINGE MAINTENANCE - CONTINUED
0027 00
ASSEMBLY
NOTE
Make sure cab side armor is assembled in correct order and has correct orientation. Thicker armor panel
(16) is installed on the outside of the thinner armor panel (15).
Make sure all holes are aligned before tightening hardware.
1.
Assemble hinge (20), outer side armor panel (16), inner side armor panel (15), and bracket (11).
2.
Install 12 bolts (12), washers (23), and new locknuts (24) on hinge (20). Tighten locknuts to 35 lb-ft (48 Nm).
3.
Install bolt (13), washer (21), and new locknut (22) on hinge (20). Tighten locknut to 35 lb-ft (48 Nm).
4.
Install engine cover latch (31), two washers (30), bolts (29), washers (32), and new locknuts (33). Tighten locknuts to 11
lb-ft (15 Nm).
5.
Install bracket (10), three washers (28), and new locknuts (27).
6.
Install step bracket (19), two washers (18), bolts (17), washers (25), and new locknuts (26). Hand-tighten locknuts.
7.
If removed, install trim seal (14) on inner side armor panel (15) from top of bracket (11) to top of inner side armor panel
(15).
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Failure to follow this warning may cause injury or death to personnel.
NOTE
Side armor assembly weighs 80 lb (36 kg).
1.
With assistance, install left cab side armor assembly
(1), four washers (8), and new locknuts (7). Tighten
1
locknuts to 23 lb-ft (31 Nm).
9
2.
Install 12 bolts (9) on cab side armor assembly (1).
Tighten bolts to 18 lb-ft (24 Nm).
3.
Align bolts holes in bracket (19) and tighten two lock-
8
7
nuts (26) to 35 lb-ft (48 Nm).
19
26
417-143
0027 00-5
