TB 9-2320-360-13&P-2
DOOR HANDLE ASSEMBLY REPLACEMENT - CONTINUED
0012 00
INSTALLATION
1.
Install standoff (5), four washers (3), two bolts (4), and new locknuts (2) on door.
2.
Position door interior spacer (19) and exterior door handle (9) on door and install four washers (11) and bolts (10) on
door.
3.
Position door linkage rod (13) on latch (8) and install linkage clevis (7).
NOTE
Make sure washers are present inside spacer before installing cam.
4.
Install five washers (18) and cam control (16) on door handle (9) and tighten setscrew (17).
5.
Install lower end on spacer (19) and install bolt (15) and new locknut (14).
6.
Install door handle (1) on door linkage rod (13) and standoff (5) with two washers (24) and bolts (23).
7.
Position door rod cover (12) on door and install eight washers (21) four bolts (22) and new locknuts (20).
8.
Install spring (6) on door.
9.
Verify correct operation of interior and exterior door handles.
10.
If necessary, adjust door latch (WP 0016 00).
END OF WORK PACKAGE
0012 00-3/(0012 00-4 Blank)
