TM 9-2330-390-14&P
5-8.
HYDRAULIC POSITIONING CYLINDER REPAIR (M1022A1 WITHOUT SIDE LIFT
KIT) (Con't).
DO NOT damage machined surface of rod assembly when placing rod assembly in
vise.
2.
3.
Place rod end of rod assembly (8) in vise.
Cant head (7) and position at rod assembly (8) with lip of rod wiper (9) started on shoulder of rod assembly.
Twist head, maintaining canted position, and slide head onto rod assembly until lip of rod wiper is fully
installed. Push head straight onto rod assembly.
4.
Install new backup seal (11) and new preformed packing (12) in rear groove of head (7).
5.
Install new preformed packing (2) on rod assembly (8).
6.
Install two stop tubes (5) on rod assembly (8).
5-28