TM9-2330-390-14&P
4-110. HYDRAULIC LIFT CYLINDER REPLACEMENT (Con’t).
NOTE
· Note position of spacer (11) to aid during installation.
· There is no spacer on right side of front dolly.
4.
Remove cotter pin (9) flatwasher (10), clevis pin (12), spacer (11l), and hydraulic lift cylinder (2) from
suspension link (8). Discard cotter pin.
5.
Remove hydraulic lift cylinder (2) and place on a clean work surface.
6.
Remove lifting device from hydraulic lift cylinder (2).
7.
Remove two lubrication fittings (5) from hydraulic lift cylinder (2). Discard lubrication fittings.
1.
2.
Clean all removed components with a clean rag.
Inspect all components for cracks, breaks, bends, corrosion, or damaged threads. Replace damaged
components.
1.
2.
Install two new lubrication fittings (5) on hydraulic lift cylinder (2).
Support hydraulic lift cylinder (2) with a suitable lifting device.
NOTE
There Is no spacer on right side of front dolly.
3.
Install hydraulic lift cylinder (2) on suspension link (8) with spacer (11), clevis pin (12), flatwasher (10), and new
cotter pin (9).
NOTE
Ensure that grease fitting at rod end of hydraulic lift cylinder Is facing up.
4.
Install hydraulic lift cylinder (2) on top beam (6) with clevis pin (7) flatwasher (4) and new cotter pin (3).
5.
Remove lifting device from hydraulic lift cylinder (2).
4-303
