TM9-2330-390-14&P
4-109. HYDRAULIC LINES REPLACEMENT (Cont).
2.
3.
4.
5.
6.
7.
If removing hose assembly (22) to far (right side)
hydraulic lift cylinder, release hose bundle from
supported position. Remove tie-down strapsfrom
abrasion sleeve (10). Discard tie-down straps.
Disconnect hose assembly (22) from hydraulic lift
cylinder (27).
If removing hose assembly (22) to far (right side)
hydraulic lift cylinder (27), lace replacement hose
assembly to hose assembly being removed. Re-
move hose assembly from inside abrasion
sleeve (10) while pulling through replacement
hose assembly.
Remove coil sleeve (28) from hose assembly
(22)
Install coil sleeve (28) to hose assembly (22),
starting 1 in. (2.5 cm) from hydraulic lift cylinder
(27) fitting.
Connect hose assembly (22) to hydraulic lift cyl-
inder (27).
4-295