TM 9-2330-390-14&P
4-48.
REAR DOLLY TAILLIGHT ASSEMBLY CABLE ASSEMBLY REPLACEMENT (Con't).
3.
If removing left side talllight assembly cable
assembly (11) remove locknut (13) flatwasher
(12) screw (8) clamp (9), taillight assembly
cable assembly, and identification light cable
assembly (10) from bracket (7). Discard locknut.
4.
If removing left side taillight assembly cable
assembly (11), remove tie-down straps from tail-
light assembly cable assembly, Identification
light cable assembly (10), and hydraulic lines.
Discard tie-down straps.
5.
Loosen three screws (19) and open cover (16) of rear junction box (20).
NOTE
Right side cable assembly wires are disconnected from positions 3, 4, 5, 6, and 8
of terminal block.
Left aide cable assembly wires are disconnected from positions 1,2,4,5, and 8 of
terminal block.
6.
Remove five screws (22) and cable assembly wires (23) from terminal block (21).
7.
Remove nut (17) and white and green ground wires (5) from upper right screw (18).
4-96