TM 9-2330-379-14&P
FRONT WHEEL TOE-IN - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
2
Left and
Four hex jam
Loosen.
right side
nuts (2)
tie rod
assemblies
(1)
3
Rear inside
Toe-in bar (4)
Attach toe-in bar (4) to rear inside edges
edges of
and 12 inch
of tire (3). Bar should be situated so
front tires
reference
that two 12-inch reference chains (5) just
(3)
chains (5)
touch the ground. Record toe-in bar
reading.
4
Lower arm
Toe-in bar (4)
Slowly roll the dolly set backwards until
assembly (6)
the toe-in bar (4) is in front of the lower
arm assembly (6). The bar should be at the
height where the 12-inch reference chains (5)
just touch the ground.
The reading on the toe-in bar should be 1/4
inch less in front of the lower arm
assembly than it was behind the lower arm
assembly.
5
Left and
Two tie rod
Turn the tie rod tubes (1) using a pipe
right tie
tubes (1)
wrench to adjust the toe-in.
Rods
The wheels should toe in 1/4 inch.
6
Four hex jam
Tighten
nuts (2)
TASK END HERE
4-74