TM 9-2330-379-14&P
COMPONENT TESTING
This task covers:
a.
Removal (page 4-59)
b. Installation (page 4-60)
INITIAL SETUP:
Tools
Equipment Condition
General mechanics tool set
Lamps removed (page 4-52)
Multimeter
Harnesses removed (page 4-57)
Resistors removed (page 4-44)
All power sources disconnected.
Multimeter set to ohms position.
ACTION
LOCATION
ITEM
REMARKS
TESTING RESISTORS
1 Resistor
Two terminals
a.
Attach one lead of multimeter to each
(1) terminal of resistor.
b.
Read resistance value indicated on
multimeter.
If meter indicates infinite resistance,
discard resistor and replace.
If meter indicates no resistance
(zero ohms; short circuit) discard
resistor and replace.
If resistance values differ by more
than 20% from proper values listed
below, discard resistor and replace.
4-59