TM 9-2330-275-14&P
4-66. REAR STABILIZER BAR REPLACEMENT (M832).
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Materials/Parts:
General mechanics tool kit
Four lockwashers
Eight locknuts
a.
REMOVAL
NOTE
Perform the following steps at left and right sides of rear dolly to remove rear
stabilizer bar.
1.
Remove two locknuts (10), Iockwashers (11), mounting bracket (9), rubber bushing (8), base clamp (7), and
U-bolt (5) holding rear stabilizer bar (12) to rear axle (6). Discard locknuts and Iockwashers.
2.
Remove locknut (13), washer (14), and bushing (15) and remove rear stabilizer bar (12) from rear dolly.
Discard locknut.
3.
Remove Iocknut (2), washer (3), three bushings (4), rod (16), and tube (17) from mounting bracket (1).
Discard locknut.
4-177