Change 6 3-2
Section I. LUBRICATION INSTRUCTIONS
3-1. GENERAL. The FSC equipment has only a limited number of moving parts that require lubrication. Perform
these lubrication functions whenever equipment is being prepared for storage or the indicated parts are not moving
freely. All specified lubrication materials are listed in Appendix E.
3-2. LUBRICATION PROCEDURES.
a. Drain Table. Lubricate linkage of the leg adapter and brace joint with general purpose oil. (Item 3, Appendix
b. Work Table. Lubricate linkage of each leg adapter and brace joint with general purpose oil. (Item 3, Appendix
Section II. OPERATOR TROUBLESHOOTIN PROCEDURES.
3-3. GENERAL. Table 3-1 lists common malfunctions that you may find during the operation or maintenance of the
FSC or its components. You should perform the tests and inspections and corrective actions in the order listed.
This manual cannot list all malfunctions that may occur nor all tests, inspections,
or corrective actions. If a malfunction is either not listed or is not corrected by
listed corrective actions, notify unit maintenance.
3-4. BURNER UNIT AND TENT. Perform operators troubleshooting on the burner units IAW TM 10-7360-204-13&P
for the M2 and TM 10-7310-281-13&P for the MBU.