TM 10-5411-224-14
4-18. DOOR ASSEMBLY - continued.
TEST (cont.)
2. Close and latch the door and withdraw the paper. If there is resistance to the withdrawal at each of the test points,
sufficient seal pressure exists, and no adjustments are necessary. If there is no resistance at the hinged side, notify your
supervisor. If there is no resistance at the roller latch side, increase the gasket compression by adding shims as follows:
ADJUSTMENT
1. Open the door and remove two bolts (14) and lockwashers (15) securing striker plate (16) requiring adjustment to
shelter panel.
2. Insert approximately 0.032" aluminum alloy shim(s) (17) between striker plate (16) and shelter panel, to a maximum
thickness of 0.096".
3. Locate striker plate (16) with added shim(s) (17) to shelter and secure with two bolts (14) and lockwashers (15).
4. Retest the door assembly for proper closure pressure and repeat adjustment procedure as necessary.
4-32