TM 10-5411-200-14
T.O. 35E4-177-1
4-17.
(cont)
4.
Install shafts (46 and 45) and flanged bearings (44) in door panel.
5.
Position pan (43) and install rivets (42).
(Refer to paragraph 4-32)
6.
Position washer (41) and outside
handle (40) and install dowel pin
(39).
7.
Insert screw (38) in mounting plate
(37) and install washers (35),
lockwashers (34), bolts (33), and screws (32).
8.
Position mounting plate (36) and install washers (35), lockwashers
(34), bolts (33), and screws (32).
9.
Position bottom rod (31), pin (30), flanged bearing (17), washer
(29), latch arm (28), and inside handle (27) and install dowel pins
(25 and 26).
10.
Position flanged bearing (17), pin (24), washer (21), spacer (23),
and latch arm (22) and install washers (20 and 21) and nut (19).
11.
Position flanged bearing (17), top rod (18), and flanged bearing
13. Refinish
(17) and Install retaining ring (16).
12. Seal (paragraph
4-42)
4-66