TM 10-5411-200-14
T.O. 35E4-177-1
4-9.
(cont)
CLEANING, INSPECTION
1.
Clean area light assembly and component surfaces.
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for and replace if necessary:
a.
Missing or damaged component
b.
Corrosion or paint damage.
R E P A IR
Repair corrosion or paint damage.
(Refer to paragraph 4-43)
ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
8.
Position two cord stowage brackets (20) on exterior light post (10)
and install four rivets (19).
(Refer to paragraph
4-32)
Install two bolts (18), washers (17), and wing nuts (16) in exterior
light post (10).
Assemble three terminal lugs (15) to three wires on one end of
electrical cord (9) and attach connector (14) at that end.
Place electrical cord (9) through clamp (12) and attach clamp to
exterior light post with two rivets (11) and close clamp.
(Refer to
4-32.)
Assemble liquid tight connector (13) to opposite end of electrical
cord (9) and install assembly in exterior light post (10). Make
sure three wires extend through opening at top of exterior light
post (lo).
Assemble locknut (21) on lamp holder (2).
Assemble lamp holder (2) to exterior light post (10) and install
thumb screw (4) and wing nut (3).
Make sure three wires extend
through opening at top of exterior light post (10).
Connect three wires from electrical. cord (9) to three wires from
lamp holder (2) as follows:
From
To
Electrical Cord
Lamp Holder
Black Wire
Black Wire
White Wire
White Wire
Green Wire
Bare Wire
4-20