• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
LOCATION AND DESCRIPTION OF MAJOR PARTS - Contd. - TM-10-5410-229-13P_18
LOCATION AND DESCRIPTION OF MAJOR PARTS - Contd. - TM-10-5410-229-13P_20

TM-10-5410-229-13P Modular Command Post System (MCPS) Green NSN 5410-01-323-2454 Tan NSN 5410-01-334-7529 Manual
Page Navigation
  2    3    4    5    6  7  8    9    10    11    12  
TM 10-5410-229-13&P 1-10. LOCATION AND DESCRIPTION OF MAJOR PARTS - Cont’d. vent flap assembly, consisting of an insect screen covered by inside and outside vent flaps, is located at each end of the roof cap.  A 5" x 6 1/4" stove pipe opening is located within an 18" x 18" stove pipe shield.  A flap with tie tapes is sewn to the upper seam of the stove pipe shield opening.  A strip of 2" wide pile fastener is sewn to the inside edges of the flap, and  a  2"  wide  hook  fastener  strip  is  sewn  around  the  outside  edges  of  the  stove  pipe  shield  opening.    A  corner  flap assembly  is  located  at  each  exterior  corner  to  provide  protection  from  water.    Strips  of  hook  fastener  are  sewn  to  the underside of the corner flap assembly.  Rope chapes are located at the peaks and sides of the roof cap.  An identification label is located on the inside.  One roof cap is provided with each MCPS. (7) Rain Gutter.  The rain gutter (7) is constructed of the same material as the plain wall.  It is approximately 13’ 3" long and 19" wide.  Eight quick disconnect male fasteners are located 18" apart  along  each  side.    A  strip  of  2"  hook fastener is sewn to each outside edge, and a strip of 2" pile fastener is sewn to each inside edge.  Strips of 2" wide hook and pile fasteners are located on each end flap.  The rain gutter provides the means to complex Modular Command Post Systems together and provide protection from the weather when two or more systems are joined.  An identification label is sewn on the side of the gutter.  One rain gutter is provided with each MCPS. (8) Floor.  The floor (8) is constructed of a coated cloth material and is 12’ 8" square.  Three quick disconnect male fasteners are located along each side of the floor.  It covers the entire floor area of the tent and provides protection from  dirt,  dust,  and  moisture.    An  identification  label  is  sewn  onto  the  side  of  the  floor.    One  floor  is  issued  with  each MCPS. (9) Support Straps.  The support straps (9) are constructed of 1" wide nylon webbing.  The straps are 10" long. A grommet is located at one end through which a hook is inserted.  Support straps are used to suspend mapboards from the frame.  Ten support straps are issued with each MCPS. (10,11) Tent  Pins,  Steel/Wood.    Eight  12"  steel  tent  pins  (10)  are  issued  for  staking  down  the  tent  frame  leg assemblies, and eight 24" wooden tent pins (11) are issued for staking down the tent lines. (12)   Frame Transport Bag.  The frame transport bag (12) is constructed of a coated cloth material.  When loaded, it is approximately 70" long, 19" wide and 9" high.  Four quick disconnect male fasteners are located along one side about 15 1-7







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.