• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR LIGHT SET - Contd - TM-10-5410-229-13P_118
REPAIR LIGHT SET - Contd - TM-10-5410-229-13P_120

TM-10-5410-229-13P Modular Command Post System (MCPS) Green NSN 5410-01-323-2454 Tan NSN 5410-01-334-7529 Manual
Page Navigation
  102    103    104    105    106  107  108    109    110    111    112  
TM 10-5410-229-13&P 5-11. REPAIR LIGHT SET - Cont’d (1)   Remove Ballast Assembly. WARNING Lethal voltage is present when the light set is connected to power source.  Disconnect from power source before inspecting or repairing any electrical component.  Electrical shock and death may result from failure to heed this warning. (a) Remove male (1) and female (2) caps from luminaire (3). (b) Disconnect lampholder (4) by depressing retainer connector (5).  Pull lamp (6) out of luminaire (3). (c) Slide the extrusion assembly (7) out of the luminaire (3). (d) Disconnect ring terminal (8) of black wire from switch with flat tip screwdriver. (e) Disconnect white AC wire (9) by removing splice (10) and separating wires. (f) If  leads  (11,  12)  from  ballast  assembly  (13)  wires  are  serviceable,  cut  the  wires  approximately  1"  from  the point  of  exit  from  the  ballast  assembly  (13).    If  the  wires  are  damaged,  remove  from  lampholders  (4)  and extrusion assembly (7). (g) Remove two 1/8" hex nuts (14) and washer (15) securing ballast assembly (13) to extrusion assembly (7). (h) Lift ballast assembly (13) off extrusion assembly (7). 2. Install Ballast Assembly. (a) Place ballast assembly (13) onto extrusion assembly (7), and secure with two 1/8" hex nuts (14) and washers (15) . 5-11







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.