TM 10-5410-221-24
(3) Seal all cracks around hinge half edges
nuts (18) from panel by drilling using a drill bit with a
with sealant PRC 611, Products RE search Co.,
diameter the same size as the blind nut.
Burbank, California, or equivalent
(6) Remove rivnut (20) by drilling using a drill
(4) Cement
seal
assemblies
using
bit having the same diameter as the rivnut.
(7) Remove screw (21), washer (22), and
g. Installation. Install the panel assembly in
remove ground rod (23).
(8) Remove rivets (24) and remove angle (25)
reverse order of removal. Refer to shelter instruction
from top edge of panel.
plate on the shelter door for procedures on securing the
(9) Remove closeout (26) from panel edge by
side panel assemble to the folding roof and folding end
inserting a knife or other sharp tool between closeout
panel:
and panel honeycomb core.
(10) Remove rivets (27) and remove angle (28)
10-5.
Folding End Panel Assemblies
from panel edge. Remove closeout (30) from panel
edge.
a. General.
The folding end panels are a
(11) Remove seal (29) by peeling from
aluminum faced honeycomb core panel. Th shelter is
(12) Remove rivets (31, 32) which secure
b. Removal.
Remove the folding end pans
angle (33) to panel bottom edge. Remove closeout (34)
assemblies as follows.
from panel assembly (35) bottom edge.
(1) Disengage all latches and hardware which
d. Repair. Repair damage to honeycomb core
secure the folding end panels to th folding floor panel
observing the procedure given on the shelter instruction
possible, straighten any bent plates, angles, or latches.
plate locate on the door.
(2) Remove the grounding straps between
e. Overhaul. Overhaul the folding end panel as
the fixed end panels and folding en panels, and between
required to return to a serviceable condition per chapter
the folding side pan, and folding end panel.
f. Assembly. Assemble the folding end panel
washers (2) and rivets (3) which secure the hinge
assemblies in reverse order of disassembly using figure
assemblies to the fixed end pane and the folding side
10-4 as a
guide and observing the following.
panels and remove th folding end panel.
(1) Install blind nuts and rivnuts using
c. Disassembly. Disassemble the folding end
manufacturers recommended procedures.
panel assemblies as required to replace damaged parts
(2) Replace rivets observing procedures
according to sequence of numbers assigned to figure 10-
4 and observing the following.
(3) Seal all cracks around hinge half edges
(1) Remove screw (4), washer (5) an rivets (6)
with sealant PRC 611, Products Re-search Co.,
to remove hinge assembly from panel. Remove blind nut
Burbank, California, or equivalent.
(9).
(4) Cement
seal
assemblies
using
(2) Remove closeout (10) from pan edge.
(3) Remove hinge pin (11) and separate
g. Installation. Install the panel assembly in
hinge half (12) from hinge half (13).
reverse order of removal. Refer to shelter instruction
(4) Remove rivets (14) and remove thermal
plate on the shelter door for procedures on securing the
strip (15). Remove bulb and tail seal from thermal strip
end panel assembly to the folding floor and folding side
panels.
(5) Remove hinge assembly (19) from panel
by removing screws (17). Remove blind
10-7