TM 10-5410-221-24
(5) Attach bellows to adjacent shelter
order of removal procedure using figure 2-11 as a guide
observing procedures given in steps (1 through 4) above,
and observing the following.
then install metal nonskid tread plates (11, 12) into
(1) Replace retainer nut (7) on bolt (6).
mounts below door openings.
(2) Place jack assembly (10) into position and
screw bolt (6) into shelter.
(3) Replace bolt (8) and flat head screws (9)
2 40.
Jack Assemblies (Fixed End)
and tighten all bolts and screws securely.
a. Removal. The fixed end jack assemblies (5,
Cargo Tie Down Installation
(1) Remove cotter pin (1) from pin (2) and
a. Removal. Removal of the cargo tie down
push pin (2) from hole.
installation shall be accomplished using figure 2-12 as a
(2) Unscrew bolts (3) from shelter panel and
guide and observing the following.
remove nut (4).
b. Installation. Install jack assembly (5, fig.
(1) Remove the rope net assembly (3, fig. 2-
12) by
removing the tie down ropes securing it to
the
2-11) in
reverse order of
removal procedure using figure
strap assembly (1).
2-11 as a
guide and observing the following.
(2) Remove the web net assembly (2) from
(1) Screw retainer nut (4) onto bolt (3).
the cargo top.
(2) Place jack assembly (5) into position and
(3) Remove the strap assembly (1) from the
insert pin (2) into hole and install new cotter pin (1).
shelter tie down fitting by disconnecting the metal ring.
(3) Secure jack to shelter with bolts (3).
b. Installation.
Install the cargo tie down
Jack Assembly (folding floor)
as a guide and observing the following.
(1) Attach the metal ring of the strap
assembly (1, fig. 2-12) to the shelter tie down fittings and
be removed observing the following.
tighten the strap assembly.
(1) Unscrew bolt (6) from panel and remove
(2) Place the web net assembly (2) over the
nut (7).
cargo and fasten securely.
(2) Remove bolts (8) from attaching bracket
(3) Place miscellaneous cargo on top of main
and the four flat head screws (9) from bottom of bracket.
cargo and secure with the rope net assembly (3) using
Remove jack assembly (10).
the strap assembly (1) as a means of attachment.
b. Installation. Install jack assembly in reverse