TM 10-5410-221-14/1
(2) Open fabric fastener tape and zipper that
9-3.
Air-Lock Chamber End Panel and Door
attaches end panel and door assembly (10) to the fabric
Assembly
body assembly (11). Remove end panel and door
a. General. The end panel and door assembly
assembly (10).
encloses the end and provides entry into the air-lock
c. Disassembly. Disassemble end panel and door
chamber. The end panel and door assembly consists of
assembly as required to replace damaged parts as
an end panel assembly and an anti-back-draft valve,
door assembly with two doors equipped with 12 inch
(30.48 cm) diameter windows.
and anti-back draft valve (3). If required for replacement,
b. Removal. Remove end panel and door assembly
peel gaskets (4, 5, 6) from anti-back draft valve (3) and
use cleaning solvent to remove adhesive from valve
(1) Remove cemented blackout curtain assemblies
housing.
1. Screw (10)
2. Lockwasher (10)
5. Gasket (2)
8. Pile fabric fastener tape
11. Ground apron
3. Anti-back draft valve
6. Gasket (2)
9 Separating pin half of zipper
12. End panel
4 Gasket (2)
7. Reinforcing tape
10. Tent pin patch assembly (2)
13. Door assembly
Figure 9-3. Air Lock Chamber Door (TS 013828)
9-4