TM 10-5410-221-14/1
conditioned air duct and clip retainer to cross bars.
assembly and engage latch.
NOTE
duct adapter clamp and free air duct adapter from flange.
Procedure also applies to adjacent side
Disengage latches by reaching through air distribution
panel assembly.
plenum zipper area. Remove air duct adapter.
disengage plenum latches and remove air distribution
panels.
plenum from bottom of flange assembly.
latches and remove flange assembly.
floor into position. Remove hook from ring assembly and
cover and secure hatches.
secure latch.
guy line rope from cable assembly. Remove ground
and cable assembly, and engage latch.
anchor with cable assembly installed.
(at least three men) and raise support assemblies out
fabric fastener tape and unzip zipper freeing air lock door
after removing pins. Lower roof.
assembly from air lock chamber.
assembly from bow spikes and pull up spikes.
assemblies to folding roof and install pins.
bow holding snap assemblies and remove bow
e. Installation of Cargo Tiedown Installation. Refer to
assemblies from air lock chamber.
the below listed instructions and install the cargo tiedown
installation.
retaining pins and disassemble bow sections.
(1) Attach the metal ring of the strap assembly (1,
fig. 4-7) to
the shelter tiedown fittings and tighten the
fabric fastener tape and unzip the zipper to remove air
strap assembly.
lock chamber from air lock adapter.
(2) Place the web net assembly (2) over the cargo
and fasten securely.
unhook drawstring from receptacle.
Disengage all
(3) Place miscellaneous cargo on top of main cargo
fasteners and pins and remove air lock adapter.
and secure with the rope net assembly (3) using the
strap assembly (1) as a means of attachment.
folding roof to end panel.
4-5. Loading and Unload Expandable Shelter
folding end panels and side panel assemblies to folding
floor latches.
a. Refer to TM 9-2330-275-14, chapter 2, section II,
for instructions pertaining to the use of a dolly set in
remove pins securing support assemblies along edge of
moving the expandable shelter.
folding roof.
b. Shelter
is
to
be
loaded
on
flatbed
trailer/trucks/railway cars only.
latch freeing side panel assemblies.
4-6. Reinstallation After Movement
4-56