M1070 HET ARMOR KIT
II113400
Rev. D
2. Install right step panel assembly as follows (see Figure 3-68):
a. Enlarge outer four holes in cab step to ∅5/8". This allows the position of the step to be lowered slightly
during re-installation for necessary clearance of the new armored door seal. In addition, it may be
necessary to trim the step brackets as shown in Figure 3-68.
b. Install right step panel assembly into position with original cab step, between welded step brackets on cab
frame and against step joiner bracket and secure with four bolts (1), eight flat washers (2), and
four locknuts (3). Torque locknuts to 35 lb-ft.
c. Install two flat washers (2) and locknuts (3). Torque locknuts to 23 lb-ft. (Be sure to lower the position
of the cab step.)
Trim these edges for
necessary clearance
2
3
2
Enlarge outer four
3
holes to ∅5/8".
Install Cab Step
1
2
JUNE 2005