TB 9-2320-360-13&P-2
RIGHT-SIDE FIREWALL ARMOR REPLACEMENT - CONTINUED
0021 00
REMOVAL - CONTINUED
10.
Remove seven bolts (19), washers (20), and firewall
bracket (21) from firewall.
19
20
21
417-213
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
1.
Install firewall bracket (21), seven washers (20), and bolts (19) on firewall.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
The right firewall weighs 113 lb (51 Nm).
2.
Using sling and lifting device, install right firewall (17) on vehicle.
3.
Feed heater control cable (18), windshield washer hoses (5), and two heater hose elbows (12) through firewall (17).
4.
Connect heater control cable (18) to heater control valve (11).
5.
Install washer hose clamp (6), five washers (4), and new locknuts (3) on right firewall (17).
0021 00-3